Pressure spray dryer is an important role in the drying equipment industry, and its application is more and more extensive. The correct installation of the pressure spray dryer is the prerequisite to ensure its normal operation, so it must be carefully installed. The following will introduce the installation procedure of pressure spray dryer:

1. Place the drying host in place, then connect the pipeline between the host and the heating unit, and place the heater in place;

2. According to the equipment layout diagram, hang the cyclone separator and bag filter at the pre-set positions in the factory building. First, connect the pipeline between the drying host and the cyclone separator, and then connect the pipeline between the cyclone separator and the bag filter;

3. Connect the pipes between the hot air stove, blower, and air filter respectively, and also connect the pipes between the bag filter and the induced draft fan;

4. Correct the verticality between the drying machine and the ground plane, and the verticality between the top of the drying machine tower and the ground should not exceed 10mm;

5. The feeder is in place and connected to the drying host;

6. When connecting each pipeline, asbestos rope or sealing strip should be embedded (silicone rubber sealing gasket is required to meet GMP requirements);

7. Fix the fasteners at each connection point until the fastener plate is tight and there is no looseness;

8. Connect the electrical cabinet circuit, and the cabinet should be firmly grounded with clear markings (wires should be threaded through pipes or wiring boxes).

The installation of the pressure spray dryer is not as troublesome as expected. As long as the installation steps are strictly followed, there will be no major problems.